BLV mgn Cube
3D Printer
Hi, my name is Ben Levi and This is BLV mgn Cube - an open-source 3D printer project. building your own good and reliable 3D printer is the main purpose of this project. Basically, it's an open front structure CoreXY 3D printer, based on
mgn linear rails for maximum accuracy, efficiency
and high print quality.
WIRING
At this point, we will install all the necessary wiring.
The wiring process is a critical step and you must perform a double check on each wire you install.
The whole process itself can take around 3 hours and sometimes more, depending on you. If you are lucky and have the FYSETC kit the whole wiring process will take about an hour. FYSETC kit has a wiring diagram has an optimized wiring diagram, all the needed cables ready to be installed, all the stepper motors wires arranged in the right order, labeled and have plugs. They created a unique PCB for the neopixel rings (5 minutes installation) based on the original neopixek project - plug and play. so it saves a lot of time. so pay attention to the type of wiring diagram you are using.
Few tips
-
Please wire your 3d printer while the AC plug is not connected to any power source.
-
make sure to crimp every cable you are connecting to the PSU (FYSETC kit cables are already pre-crimped).
-
Don't mix negative and positive wires
-
double check every wire.
DUET 2 WIFI WIRING
If your fans rated as 12V and you want to use them
on a 24V - this is the right way to wire them without damaging the board/fans.
Click on the picture to enlarge it
The NeoPixel rings installed on the front panel and display your 3d printer status with animations.
rings add-on Arduino code source:
Click on the picture to enlarge it
DUET 3 BASIC WIRING
IF you are lucky enough to have the Duet 3 board - this is the wiring diagram for you.
FYSETC OPTIMIZED WIRING - for fysetc kit only
BL-TOUCH WIRING
Fysetc kit comes with a bl-touch autoleveling sensor, this is the wiring diagram.
TURN ON BUTTON - RELAY MODULE
FYSETC - BLV Neopixel module WIRING
5 minutes installation - this is how you wire the neopixle rings. all the cables are ready, neopixles has pins soldered on them and ready to be installed. You can't go wrong with the plugs 2pins and 3 pins, piece of cake!
